22-104c

Sicass Racing Orange Lens LED Flex Mount - KTM

2 reviews

LED turn signals with an adjustable mounting stock to prevent breaking them off. Turn signals measure 2.25" wide and 1" tall with a through bolt mount.

FITMENT
KTM EXC 2007-2022
KTM 690 2009-2016
Husqvarna FE-S Models 2014-2016
Husqvarna FE Models 2017-2019
Husqvarna FE-S Models 2020-2022

NOTE:

  • If installing on a 07-22 KTM EXC, a 2014-16 Husqvarna FE-S, a 2017-19 Husqvarna FE, or a 2020 Husqvarna FE-S you may also need parts 22-298 and 22-300. (SEE BELOW)
  • *If you plan to use LED turn signals on the front AND rear, then you will need to install the 22-298 AND the 22-300.
  • *If running one set of LED and one set of standard bulb turn signals you do not need the 22-298 nor are you required to install the 22-300 smart flasher. In this case the turn signals will blink slightly faster. If you wish to correct the flash rate install the 22-300.

PROPOSITION 65

⚠️WARNING

This product can expose you to chemicals known to the State of California known to cause Cancer or birth defects and reproductive harm. For more information go to: https://oehha.ca.gov/proposition-65

Customer Reviews
4.0 Based on 2 Reviews
5 ★
0% 
0
4 ★
100% 
2
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
Customer Photos
Write a Review

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
    EP
    12/20/2022
    Eric P.
    United States

    great signals

    They give a much cleaner flush look and are plenty bright. After replacing both the front and rears with these LED's the blinking was about the same frequency as stock so I did not have to adjust for a faster blink rate.

    WB
    01/18/2019
    Warren B.
    United States

    Sicass LED flex turn signals

    Make sure to order the Sicass resistors 22-690 if you are installing LED’s on front and back on KTM 690 Enduro. No instructions with the turn signals, some directions on the back of resistors. Long story short, plug and play turn signals only on the rear, plug resistors into on each turn signal on the front. I ran a zip tie through the two holes on the black plate to secure the resistors away from other wiring,

    KTM Twins Sicass Racing Orange Lens LED Flex Mount - KTM ReviewKTM Twins Sicass Racing Orange Lens LED Flex Mount - KTM Review

    be the first to know