Your Cart is Empty
SPL1P
$15.00
Replacement spindle with bearings, nylon locking nut, reusable thread locker, and Oring included. We apply a thread-locking coating but highly recommend in addition to this applying a Permanent thread locker before installing a new spindle to the mount. This will provide an extra safety step to help keep the spindle from backing off due to vibration. Any name-brand permanent thread locker will do the trick. Make sure you check the spindle on a regular basis. Vibration and impact can cause threads to loosen. Since we use high-strength thread lockers when installing our spindles during assembly. You will need to apply heat to the base of the spindle when trying to remove the spindle. This will help release the bond on the threads.
*IMPORTANT* The Nylon lock nut torque spec is 2 ft/lbs (hand tight) Use an 8mm socket. Once to feel it bottom out stop tightening and visually inspect to make sure the nylon in the nut has engaged with the last couple of threads on the spindle. Over-torquing/tightening will cause the threads to strip and fail.
The spindles are made of Chromoly steel that has been failure-tested to meet our high industrial standards. Each batch of hardware must meet testing standards.
These Spindles are designed to be able to bend back straight in most cases. Steal has great fatigue strength when it comes to getting bent. Footpegs tend to take the most abuse out of all the components. We designed our hardware to bend rather than break in a major impact. The idea is that the spindle will bend before the platform you stand on does. This means that the cheapest and easiest part to replace fails rather than the more expensive platform. Plus keeping a spare spindle in your pack doesn't take up much space and is cheap insurance to make sure your ride doesn't get ruined.
We find that a wrench or adjustable wrench will quickly and easily bend the bolt back straight. Please avoid using a hammer. I little leverage from a long-handled wrench or pipe is all that's needed.
Always use a high-strength threadlocker when installing a spindle. We use a multiple-use thread locker on the threads along with a Viba-Tite 541 Joining Compound This is a high-strength permanent thread locker that may need heat to remove in some cases. So if you have to remove the spindle for any reason it will need to be reapplied. We also use an innovative second thread locking system that uses a nylon rod insert and grabs the threads to prevent loosening from vibration. Spindles should always be torqued to 40 ft-lbs with a 14mm wrench.
We understand that repairing a footpeg rather than trashing it and replacing it is a different way to look at the current market and is not for everyone. So take this into consideration when buying. These are fully rebuildable footpegs. Service intervals of 40hrs are always recommended to check the hardware and regrease the spindle axels or replace bushings.
These are not covered in the lifetime warranty and are considered a wear item.
This product can expose you to chemicals known to the State of California to cause Cancer or birth defects and reproductive harm. For more information go to: https://oehha.ca.gov/proposition-65
