RGR0001
$7.99
Are your micro / mini indicators flashing incorrectly?
In many cases, after fitting micro / mini indicators, you will find that the indicators flash too fast or too slow. To stop this, R&G Resistors can be fitted which should solve the problem.
For R&G Bulb Indicators - Select the 9.8 Ohm resistor (RGR0001)
Includes one pair of 9.8 ohm resistors with bullet connectors.
Using R&G’s replacement Micro Indicators LED turn signals together with these resistors simulates the power consumption of 21-watt original incandescent bulbs. Here’s the math: At 13.4 volts a 9.8 ohm resistor produces a 18.3 watt load. Add in a 2 watt LED indicator and you’re at about 21 watts total.
Not for use if:
For R&G LED Indicators - Select the 21.5 Ohm resistor (RGR0002)
After replacing your bike’s original 10 watt incandescent turn signals with R&G Micro Indicators incandescent turn signals (RG370) OR after replacing your bike’s original 10 watt incandescent turn signals with R&G Micro Indicators LED turn signals (RG371) you may find that the signals flash too fast or too slow. Adding this resistor resolves this issue. No cutting crimping or soldering required.
These are inline resistors NO wire cutting or soldering required.
Includes one pair of 21.5 ohm resistors with bullet connectors.
Not for use if:
This product can expose you to chemicals known to the State of California known to cause Cancer or birth defects and reproductive harm. For more information go to: https://oehha.ca.gov/proposition-65
The fit and performance of the resistors were as advertised. The L.E.D. blinkers operate faster than a normal rate but they work and fit the 2011 KTM 690r well. Was planing on using the other pair I purchase on a 2008 KTM 990 when I have the $$ to purchase the LED turn signals front and back.KTM Twins did a good job letting me know about the status of my order.