Your Cart is Empty


KTM Power Socket Kit 1090 Adventure R 2017-2019

#2 Best Seller
in Electrical
8 reviews
This OEM part is in stock and ships in 1-2 business days.
1 item left

Necessary when a source of power is needed for a navigation system or for any other device.


    • KTM 1090 Adventure R 2017-2019



    This product can expose you to chemicals known to the State of California known to cause Cancer or birth defects and reproductive harm. For more information go to: https://oehha.ca.gov/proposition-65

    Customer Reviews
    4.6 Based on 8 Reviews
    Write a Review

    Thank you for submitting a review!

    Your input is very much appreciated. Share it with your friends so they can enjoy it too!

    Filter Reviews:
      bill c.
      United States United States

      The updates are hilarious. Although sometimes they come through during the wee hours of night

      Cody H.
      United States United States
      Plug and play

      Works perfect with KTM 1090 adventure R. Have to remove most side paneling to connect wires and tighten securely.

      Diana A.
      United States United States
      Install can be tricky

      Without completely disassembling the fairing, installation is tricky. Securing the power socket requires you to tighten a nylon nut from underneath the fairing housing, of which, access is extremely limited. After numerous attempts, I finally used a few drops of a good bonding glue to secure the nylon nut to the underside of the fairing housing. Once it dried, I carefully screwed in the outlet (with the wire harness) until snug and then connected the wire harness to the switched ACC connectors. That worked like a champ!

      Reid A.
      United States United States
      12 v power socket.

      Product arrived in good condition. Top cap is thin plastic and poorly designed making a tight seal to keep water out very difficult.

      Brian L.
      United States United States
      2019 ktm 1090 adventure R

      havent installed it yet. need to identify the 4 wire end avalible at the left top console area under the existing cigerrett opening. assuming one pair is acc1 and one pair is acc2. one pair being shared with the existing dash control circuit adn one pair that is direct from the battery. i have seen where the direct pair and a relay with the control pair is used, just need the relay?

      be the first to know