Denali's PowerHub 2 Fuse Block Accessory Hub is by far the best way to cleanly wire all of your accessories to your bike. This eliminates the mess of wires from multiple add on's to your battery causing your bike to be a nightmare when servicing. The PowerHub2 allows you to centrally locate all of your accessories power and ground leads into one spot on the bike in a very clean and professional fashion. If you intend on running more than a set of heated grips for example then you should consider the purchase of the PowerHub. This is one of the those purchases that should be considered before installing anything. It will make your life much easier in the end.

The PowerHub2 Power Distribution Module allows you to safely connect up to 6 electronic devices to your motorcycle in a clean, professional manner. It is CAN-Bus compatible and includes six 15-amp rated and fused outputs, six ground posts, and a plug-and-play wiring harness for direct battery hookup. Each of the six outputs can be individually set as "always on" or "switched" on/off with the ignition of the motorcycle. Instead of attaching multiple ring terminals to your battery, use a PowerHub2!

The CAN-bus safe Denali PowerHub2 has been designed to allow simple and easy installation of electrical components. Each unit has six individually fused outputs. These are not your ordinary outputs. Simply plug the fuse in to the left or the right on the circuit board to make the accessory live all of the time or switched on/off with the bike's ignition.

The entire unit is rated for 30 Amps (360 watts). Each of the six circuits can handleup to 15A (180W) each - without exceeding a total sum of 30 Amps simultaneously.

• This is a universal fit part; it may or may not fit without modification.

⚠️WARNING

This product can expose you to chemicals known to the State of California known to cause Cancer or birth defects and reproductive harm. For more information go to: https://oehha.ca.gov/proposition-65