The instructions are fine, however, when I put the mounting bracket on the following happend, I tightened the two grub screw as per instructions and the area where the grub screw for adjusting the height of the mount adaptor cracked on the top and bottom. I had to remove it and use some liquid steel to repair it. I put it back on and put the Mount adapter on before I set and torqued the two grub screws on the left and right side. That problem was solved, then when I went to adjust the height of the steering dampner pin I found that either the grub screw is too short or the pin is too short. I had to put in a spacer to make it fit properly. These things need to be looked after. Other wise I will get a chance to test it out when I take my bike down to Nevada.