same great site, all new look for 2019!

0

Your Cart is Empty

RRP 010

Rally Raid Foam Air Filter Conversion Kit KTM 690 Enduro/SMC 2008-2017

#4 Best Seller
in Rally Raid
9

Customer Reviews

Based on 3 reviews Write a review

Unlike all other foam air filters for the KTM 690 Enduro and 690 SMC, this one keeps it simple and strong. It includes a black powder coated aluminum cage and stainless steel screw for mounting. It also includes a Hi-Flo Foam Filter to round out the package.

Keep the air clean and you'll keep your engine clean. Simple as that.

Replacement Filter

FITMENT

  • KTM 690 Enduro 2008-2017
  • KTM 690 SMC 2008-2017

PROPOSITION 65

⚠️WARNING

This product can expose you to chemicals known to the State of California known to cause Cancer or birth defects and reproductive harm. For more information go to: https://oehha.ca.gov/proposition-65

Customer Reviews

Based on 9 reviews
5 ★
67% 
6
4 ★
22% 
2
3 ★
0% 
0
2 ★
0% 
0
1 ★
11% 
1
Write a Review
  • Reviews

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

    JA
    08/17/2018
    Jason A.
    United States

    Clumsy

    Not as easy a fit as it would seem. Can’t use grease as a traditional seal gets all over. Over thought design meant to be simple but poor fitment and clumsy.

    BS
    08/06/2018
    Brad S.
    United States

    Nice upgrade/mod overall

    The good: The install was easy, little bit of silicone work, let it set 24hours and good to go. It replaces stock air intake and airbox above the paper filter only, airbox below filter stays intact and can be converted back at anytime if you break the new silicone seal. I have only tried this at high elevation so any peformance gains I could not comment on. Does a great job of keeping out dust and dirt, found no bleed through upon cleaning. I use no toil and filter skins, worked great for a couple hundred miles of dust. The bad(ish): not impressed with the fit of the base plate tabs, lots of play in original tab slots, so silicone must be right and complete or you will have major problems, also a silicone failure means the whole plate is loose and major air gaps would occur. The intake noise is now quite loud and throaty. Sounds good, like a ducati, but can be annoying when accelerating around 4-5k rpm. Filter gets dirty quick and has direct airflow to it without the stock air intake routing. Needs to be cleaned often. Overall, still a good purchase, if you are riding serious dirt and dont mind additional maintenace, you need this!

    J
    02/23/2018
    Joe
    Alberta Canada

    Filter system is fine, install method isn’t great

    The filter is fine as is the install and removal each cleaning cycle. The primary install requires you to apply silicone to the top of the air box then screw down the metal base of the filter using the factory air box cover fasteners. It’s difficult to ensure your silicon has made a perfect seal. This product should come with a thick rubber gasket to ensure a proper seal and should not relay on the customer to apply silicon.

    MV
    08/04/2017
    Miguel V.

    Rally Raid foam filter will give some changes

    I've recently acquired this Rally Raid foam filter, looks great, it came with a cage, I will test it soon and I hope to have good results, but definitely it's better than paper filter.

    PG
    05/02/2017
    Pascal G.

    Perfect

    No more sand in air box, easy to clean and install

    be the first to know